The Best Number 9 Drill Bit In Fraction References


The Best Number 9 Drill Bit In Fraction References. Fraction of an inch inch mm fraction of an inch inch mm fraction of an inch They can be made in any size to order, but standards organizations have defined sets of sizes that are produced routinely by drill bit manufacturers and stocked by distributors.

115pc Titanium Drill Bit Set w/ Index Case Number Letter Fractional
115pc Titanium Drill Bit Set w/ Index Case Number Letter Fractional from www.amazon.com

Number drill bit sizes & letter drill bit sizes. Drill size number drill size letter drill size fraction drill size metric decimal equivalent 0.1 0.0039 0.2 0.0079 0.3 0.0118 1/64 0.0156 0.4 0.0157. In the us, there are two standard ways of measuring drill bits.

The Decimal Equivalents Of The Diameters Are Shown In Both English And Metric Units.


387 rows drill size chart. Drill bits are the cutting tools of drilling machines. The drill size chart provides a list of standard size drill bits in several measurement systems, including fractional, metric, wire gauge number, and letter.

There Are 25.4 Millimeters (Mm) In An Inch.


All over the world, one of the metric or imperial units is used as the general unit. The drill size chart below gives fractional sizes and their metric conversions up to 1 inch. However, standard fractional drill bits come in intervals of 1/64 inches.

Eng Form Last Updated On:


Due to rounding, a 9/64 drill bit will make the hole smaller than a #25 drill bit and a 5/32 drill bit will make the hole larger than a #25 drill bit. If appropriate for your class or particular students you could open the numerator to all rational numbers. Below we converted the fractions to decimals so you can compare more easily:

Please Send Corrections And Comments To:


If all else fails, you may want to use our tap drill size calculator. The number drill bit gauge sizes range from size 80 (the smallest) to size 1 (the largest) followed by letter gauge size a (the smallest) to size z (the. M · 1 + 0.75 mm.

Number And Letter Gauge Drill Bit Sizes:


The information available from our sources is usually. Below we converted the fractions to decimals so you can compare more easily: M is an integer between 14 to 25.